Filter
Top Products
128-6122
2 of 4
PROGRAMMING THE TRANSMITTERS
It is important to remember that during programming, each individual step of the
procedure must be executed within 15 seconds of the previous step.
When the 15 second time limit is allowed to expire, the system will automatically
terminate the programming mode. This is indicated by a long chirp from the siren.
NOTE: Some keyless entry systems will flash the interior light to indicate a
stored code. Substitute the words light flash below where indicated
sounding device will beep.
Additionally, the system will store codes from up to four different transmitters.
If a 5th transmitter is programmed to any receiver channel, then the first
transmitter programmed to that channel will be erased from the system's
memory.
To Program replacement or additional transmitters:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet push-button switch 3 times.
3. The dash LED will flash one time, and the sounding device will beep one
time, indicating the system is ready to accept programming for receiver's
Lock channel 1.
4. Press and hold the Lock transmitter button until the sounding device emits
a long beep, indicating the signal has been stored into memory.
5. If you have additional transmitters (up to 4) that need to be programmed,
repeat step 4 for each transmitter.
6. Press and release the valet push-button switch once.
7. The dash LED will flash two times, and the sounding device will beep two
times, indicating the system is ready to accept programming for receiver's
Unlock channel 2.
8. Press and hold the Unlock transmitter button until the sounding device emits
a long beep, indicating the signal has been stored into memory.
9. If you have additional transmitters (up to 4) that need to be programmed,
repeat step 8 for each transmitter.
10. Press and release the valet push-button switch once.
11. The dash LED will flash three times, and the sounding device will beep three
times, indicating the system is ready to accept programming for receiver's
channel 3.
12. Press and hold the selected Option transmitter button until the sounding
device emits a long beep, indicating the signal has been stored into memory.
13. If you have additional transmitters ( up to 4 ) that need to be programmed,
repeat step 12 for each transmitter.