Filter
Top Products
7
7
once you have toggled past it. Should you accidentally toggle past the feature you wanted to program, you must exit
and re-enter the Programming Mode and then adjust the feature you missed.
It is also important to note that you may toggle past as many programmable features as you wish without having
to adjust them. Each time you toggle forward to a new feature, the siren will chirp the appropriate number of times
(1 or 2 times) to indicate how that feature is currently set, and the LED will flash the appropriate number of times
to indicate the number of the feature (First through Fifth) that you are set to adjust. For example, you might enter
the mode and toggle the Valet/Program/Manual Override Switch 3 times in order to adjust the Fourth program-
mable feature. The system would respond with 1 Chirp, and the LED would begin to flash 4 Flashes, pause, and
repeat. This has told you that the system is ready for you to adjust the Fourth programmable feature and that it is
currently programmed for Chirps ON. A single press of button 1 of the transmitter will cause the system to produce
2 Chirps. This signifies that you have changed the programming to Chirps OFF. Please follow the programming
procedure carefully and refer to the list of the Programmable Features above when programming this system.
To program these selectable features;
Action System Response LED Pattern
Turn ignition on No response
Turn the valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = passive arming 1 flash pause
Press transmitter Lock button to change 2 chirps = active arming
or
Second Turn the valet switch on the off 1 chirp = auto locks on 2 flash pause
Press transmitter Lock button to change 2 chirps = auto locks off
or
Third Turn the valet switch on the off 1 chirp = auto unlock on 3 flash pause
Press transmitter Lock button to change 2 chirps = auto unlock off
or
Fourth Turn the valet switch on the off 1 chirp = passive lock 4 flash pause
Press transmitter Lock button to change 2 chirps = active locks
or
Fifth Turn the valet switch on the off 1 chirp = chirps on 5 flash pause
Press transmitter Lock button to change 2 chirps = chirps off
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between
steps, or the programming will be terminated.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the unit and tested any and all optional features of the system:
1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be
certain that the chosen mounting location will not inhibit any of the controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in
contact with under the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around
these mechanisms and impair the safe operation of the vehicle.
3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation and retest the system.
5. Explain the operation of the system and its various features to the end user if available and place the
Owner's Manual on the dashboard for them to find and review.