Filter
Top Products
Page 2
YOUR " ANTI CODE GRABBING " TRANSMITTERS
The transmitters included with your new security system use the most advanced and secure form
of radio frequency transmission available on any current automotive security system. Some of
today’s sophisticated auto thieves use a device known as a code grabber, which will receive and
store the signal from your keychain transmitter, and re-transmit at a later time to disarm your
system.
Your anti code grabbing transmitters will change their signal every time the button is pressed, so
when a thief grabs then re-transmits your signal, the alarm system
will not
respond.
If your transmitter button is pressed more than fifty times while it is out of range of the vehicle
(children playing with your keys), the transmitter will not operate when you return to the vehicle,
and will need to be re aligned to the receiver. To do this, simply press the Lock button two times
within a one second time period. The system will now respond to that transmitter each time a
button is pressed.
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and release the Lock button on the keychain transmitter.
þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren sounds one chirp.
If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the siren did not
sound when arming, then the chirps have been turned off, and you should refer
to the section titled " ELIMINATING THE ARM / DISARM CHIRPS " in this manual.
o Vehicles horn beeps one time.
If the horn beeps three times, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the horn did not
sound when arming, then the chirps have been turned off, and you should refer
to the section titled " ELIMINATING THE ARM / DISARM CHIRPS " in this manual.
þ Doors Lock
o Headlight Illumination - Optional
The vehicle’s headlights turn on for approximately 30 seconds, illuminating the
path as you leave the vehicle.
SILENT ARMING - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and hold the Lock button on the keychain transmitter for 2 seconds.
þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren will not sound.
If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection.
o Vehicles horn will not beep.
If the horn beeps three times, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection.
þ Doors Lock
o Headlight Illumination - Optional
The vehicle’s headlights turn on for approximately 30 seconds, illuminating the
path as you leave the vehicle.
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid.
þ Red dash mounted LED begins to flash rapidly, indicating 30 second passive
arming has begun.
2. Opening any protected entry point during the 30 second passive arming cycle will immediately
suspend automatic arming, and the 30 second passive arming cycle will re-start when all doors
are closed. At the end of the passive arming cycle;
þ Red dash mounted LED begins to flash slowly.