Filter
Top Products
128-7777
4 of 8
4
TO ENTER THE VALET MODE:
1. Disarm the unit by use of the factory transmitter or by use of the manual override
sequence.
2. Turn the ignition switch to the “On” position.
3. Press and hold the valet/override pushbutton switch for 5 seconds. The LED
turns on, indicating valet mode has been successfully entered.
TO EXIT VALET:
With the ignition switch in the on position, press and release the valet/override
pushbutton switch one time. The LED turns off indicating the valet mode has
successfully been exited.
MANUAL OVERRIDE OPERATION:
If your factory transmitter is lost, broken, or otherwise rendered inoperable, your
system can be overridden allowing operation of the vehicle. The manual override
code is pre-programmed at the factory to 11. This code can be changed by the
operator to a more familiar two digit number. Once you’ve become familiar with the
system’s operation and override procedure, we suggest you change the code for
added security.
NOTE: The override procedure below describes use, assuming that the factory
pre-set code has not been changed and is still set to the factory default 11.
The valet/override push button switch is used to enter the tenths and units
digits, pressing and releasing this button one time for each digit required.
To manually override your system, with a code of 11, follow the sequence listed
below:
1. The LED is flashing indicating unit is armed, enter the vehicle, the siren will
sound, turn the ignition switch to the “on” position.
2. Within 10 seconds begin to enter tenths digit of override code. (In this ex-
ample the code is 11, so press and release the Valet/Override pushbutton
one time).
3. Within 10 seconds of entering the last tenths digit, turn ignition “off then on”.
4. Within 10 seconds of turning the ignition switch on, begin to enter units digit
of override code. (In this example the code is 11, so press and release
the Valet/Override pushbutton one time).
5. Within 5 seconds after the last units digit is entered, turn the ignition switch
off, then on, and start your vehicle.
If the manual override code is entered properly, the unit stops sounding, the LED
turns off, indicating a successful override. The system is now disarmed and you
can start and operate your vehicle. The unit will allow three attempts to disarm via