Filter
Top Products
Page 7
defective zone indicator will always operate. Since these are important warnings to
you that something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The Lock or Unlock button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the Lock or Unlock button on the keychain transmitter for 3 or more
seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock or Unlock button on the transmitter again for 3
seconds. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Also if any transmitter button other than the Lock or Unlock button is pressed and released,
the Panic mode will be turned off immediately. The normal function of this transmitter button
will be suspended during the Panic sounding period.
NOTE: While in the Panic mode, pressing and releasing the Lock, or the Unlock buttons will, if
the option is installed, lock and unlock the doors respectively. While in the panic mode,
anytime the unlock button is pressed, the panic feature will continue for the allotted 30
seconds, however, the security system will be disarmed allowing the vehicle to start.
SAFETY (Red Handled ) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of your
system. For safety, this switch must be turned off for vehicle servicing. To disable the unit,
move the red handled control switch to the off position.
The control switch also allows you to select between 2 hour start up and 4 hour start up when
using the automatic start up timer mode. The factory preset start up time for this mode is every
4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a 2
hour start timer. After 10 seconds expire, the parking lights will flash and the siren will chirp
2 times confirming that the two hour start cycle is set. Or, within 10 seconds move the
control switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start timer.
The parking lights will flash and the siren will chirp 4 times confirming that the 4 hour start
timer is set.
REMOTE STARTING THE VEHICLE
The Remote Control Unit WILL NOT start the vehicle if any one of the following conditions
exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The Safety Control Switch Is In The Off Position.
CAUTION ! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start
the vehicle if it is garaged.
TO REMOTE START THE VEHICLE:
Press and release the transmitter button with the "Trunk/Key" symbol on it, two times within 2
seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, or 20
minutes. As a visual indication, the parking lights will flash or turn on depending on the