Filter
Top Products
Page 3
protected entry points. If the thief left a door opened, the alarm will sound for six 30
second cycles, remain armed and ignore that triggered zone.
þ Whenever the system is armed, the red dash mounted LED indicator will slowly flash.
This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb and will not cause the vehicle’s battery to drain, even when left unattended for
extended periods.
þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30
second alarm cycle, attracting visual attention to the vehicle.
o Optional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed.
If the thief should choose to ignore the siren/horn, the vehicle can not be started.
o Optional - Any strong impact to the vehicle will cause the alarm to trigger for the full 30
second alarm cycle.
o Optional - Any mild impact to the vehicle will cause the alarm to sound a short series of
warning tones.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Disarm / Unlock button on the keychain
transmitter.
þ Red dash mounted LED turns off.
If passive arming was selected during the installation, then the LED will
start flashing rapidly, indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.
þ Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify which
zone was triggered.
þ Siren / Horn sounds two chirps.
If the siren/horn sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
If the siren/horn did not sound when disarming, then the chirps have been
turned off, and you should refer to the section titled "ELIMINATING THE
ARM / DISARM CHIRPS" in this manual.
o Doors Unlock - Optional
SILENT DISARMING
1. As you approach the vehicle, press and hold the Disarm / Unlock button on the keychain
transmitter for 2 seconds.
þ Red dash mounted LED turns off.
If passive arming was selected during the installation, then the LED will
start flashing rapidly, indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.