Filter
Top Products
Page 8
Note: The siren will sound.
2) Within 5 seconds, press and release the pushbutton switch 1 time.
3) Within 5 seconds, turn the ignition switch off then on.
4) Within 5 seconds, press and release the pushbutton switch 1 time.
5) Turn the ignition switch off then on and start the vehicle.
Note:If you have changed the programmed override code then substitute your
new code tenths for step 2 above, and units for step 5 above.
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any
time you arm or disarm the system simply by holding the ARM / DISARM button
for two seconds. If you find the normal arming and disarming chirps annoying,
they can be turned off permanently, eliminating the need to hold the ARM / DISARM
button for two seconds.To do this,
1. Turn the ignition key on then off.
2. Within 10 seconds, press and release the valet push button switch
three times.
3. If the chirps were on before you started, then you will hear 2 chirps
indicating they have been turned off.
If the chirps were off before you started, then you will hear one chirp
indicating they have been turned on.
NOTE: Whenever the chirps are by-passed, the 4 chirp intrusion indicator and 3
chirp defective zone indicator will always operate. Since these are important
warnings to you that something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The ARM or DISARM button on your keychain transmitter also functions as a
panic switch for use in emergency situations. To use remote panic,
1. Press and hold the ARM or DISARM button on the keychain transmitter
for 3 or more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the
transmitter again for 3 seconds. If the button is not pressed, the
alarm will automatically stop after 30 seconds. Also if any transmitter
button other than the ARM or DISARM button is pressed and released,
the Panic mode will be turned off immediately. The normal function
of this transmitter button will be suspended during the Panic sounding
period.
3. During the panic mode, the Lock and Unlock buttons can be used to
lock and unlock the doors, (if the option is installed), however once
the unlock/disarm button is pressed, the vehicle's starter inhibit
device, (where installed) will be disabled allowing the vehicle to start.
NOTE: While in the Panic mode, pressing and releasing the ARM or DISARM
buttons will, if the option is installed, lock and unlock the doors respectively.