Audiovox NPSWR Remote Starter User Manual


  Open as PDF
of 6
 
☞
Insert a new Lithium battery “CR2” type. Pay attention to correct polarity (marked
in the compartment).
☞
Close the battery compartment.
☞
Reattach the remote control to the steering wheel.
Notes:
In many countries used batteries may not be disposed of with your household waste.
Please determine how to dispose of used batteries according to local regulations.
Troubleshooting
In rare instances, your Steering Wheel Remote Control may not function the way you
expect it to. Before calling for service please read the operating instructions and go
through the following check list; it may be possible to easily remedy an apparent mal
-
function.
Symptoms Possible cause / remedy
Navigation Systems
System does not or not always react to key
presses on the remote control.
Battery of the remote control is discharged.
• Replace the battery with a new one of the same type (CR 2).
See section “Replacing battery of the remote control”.
Interference of the IR receiver built in the Navigation Monitor by strong
solar radiation into the vehicle.
• If possible try to find a more suitable position for the remote control on
the steering wheel.
IR-link covered by fingers, arm or subjects.
Audio mode selected:
• Set Mode switch on the Remote Control to “N”.
Steering Wheel Remote Control is not “registered” to the Navigation
System.
• Activate “Steering Wheel Remote Control” option in the System
Settings menu of your Navigation System.
Supplied remote control is still placed in its holder.
• Remove remote control of the Navigation System from its holder.
After the first press on OK the system does
no longer react on the Steering Wheel
Remote Control.
• Set Mode switch on the Remote Control to “N”.
• Activate “Steering Wheel Remote Control” option in the System
Settings menu of your Navigation System.
Service
For Tech Service, call Audiovox at 1 800 225-6074.
Subject to technical modifications and errors.
6
 previous