Filter
Top Products
Monitor Wiring
1. Using the supplied Monitor Signal Wire, Plug one end into the Power / signal
cable from the bar.
2. The monitor signal wire can be routed through the car to your chosen location
for the monitor by either removing the trim panels at the foot of the door sill
or by tucking the wire behind the trim panels at the roof of the vehicle.
3. Use caution to insure you do not pinch the wire or obstruct any safety devices
such as side airbags. If your vehicle has side air bags we recommend you run
the wire at the door sill plate location.
4. With the wire run to the Monitor location you have chosen, plug the signal
wire into the monitor cable.
Monitor Installation
The monitor, with flexible mounting foot and double sided tape, mounts on either
the vehicle windshield or dashboard
.
1. Choose a monitor location in your vehicle that does not block your view for
safe driving.
2. Clean the monitor base and mounting area with a cleaner that does not leave a
residue.
3. Remove the protective film from one side of the double sided tape and from
the bottom of the monitor base. Next, remove the protective film from the
other side of the double sided tape and carefully position the monitor and
press into place.
NOTE: Once adhered, the pad cannot be easily moved. Be sure of the position
before mounting.
If needed, tighten the screw on the back of the mounting foot support arm to
ensure that the monitor stays in the set position. Be careful to not use too much
force and damage the unit.
8