Filter
Top Products
Dark Blue/Black and Green/White - 2 Pin Input/Output Harness:
Dark Blue/Black Trace Wire: External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external source. The
intent of this wire is to allow the unit to be controlled from a "POSSE/CAR-LINK" paging system or similar
device. When this wire receives a ground pulse, the unit will start the vehicle. Connect this wire to a
ground pulsed output from the controlling circuit.
Green w/ White trace Wire: Entry Illumination Ground Output
This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to unlock the
doors . This wire should be connected to an external relay, and wired to the vehicles interior entry lighting
whenever the optional Interior Illumination circuit is desired. See below for relay wiring details.
Entry Illumination Detail
1. RF Programmable Features:
Feature 1 Flash 2 Flash 3 Flash 4 Flash Default
1st Door Lock O/P 1S/1S 3.5S/3.5S 1S/Dbl1S 1S/1S
2nd Auto Locks On Off Off
3rd Auto Unlock Dr. Door All Doors Off Off
4th Run Time 5 Min 10 Min 15 Min 20 Min 10 Min.
5th Lights On Steady Flash Steady
6th Input Check NA Tach Tach
7th NA NA NA NA
8th Ign 2 Crank Off On On
9th Diagnostics Off On Off
10th NA NA NA NA NA NA
11th Gas/Diesel Gas Diesel 10 Diesel 15 Diesel 20 Gas
12th 2nd Step Unlock On Off Off
NOTE: When selecting Diesel operation, (Feature #11), over gasoline, the only change is to the ignition
circuits. When Diesel is selected, the ignition circuits will power up for X seconds, as dictated by
the feature selection, before the start circuit. The intent of this feature is to allow the glow plug
warming required by some diesel engines. If your vehicle is a instant start diesel, it is not necessary
to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be
certain to connect the tach input wire.
To program these selectable features:
1. Turn the ignition key to the ON position.
2. Press and release the pushbutton switch 3 times
3. Immediately turn the ignition key OFF, then back to ON.
4. Press and release the pushbutton switch 2 times.
13
2