Filter
Top Products
128-7407
1 of 12
Model APS-597
Installation Manual
SELECTABLE FEATURES
The selectable features can be set manually as explained below, or with the RF feature programmer.
To set features using the RF programmer, follow the instructions packaged with the programmer.
Factory default settings are indicated by bold text.
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.
RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features:
Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps Default
1st DoorL/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L Dbl L, 1 Sec UL Dbl L, Dbl UL 1 S l/350mS ul 1S/1S
2nd Accy Lock Accy Lock On Accy Lock Off Auto Locks Off
3rd Accy. UL Accy UL Dr. Accy UL All Accy U/L Off Auto UL Off
4th Headlights On Arm On Disarm On Both Off w/ Arm& Disarm
5th Passive Locks Passive Active Active
6th Pass/Act Arm Passive Arm Active Arm Active
7th Siren/Horn Siren/Horn Siren Only Horn Only Siren/Horn
8th Horn Chirp 10mS 16mS 30mS 40mS 50mS 16mS
9th O/R Method Custom Code Valet Valet
10th 2 Step U/L On Off Off
11th Chp Del Tx On Off Off
12th Volts/HdWire Voltage Sense Hardwire Hardwire
13th Trigger Ckts NA
14th L/UL Poll NA
When using the RF programmer, enter the program mode as follows:
Turn the ignition on
Press and release valet switch 3 times
turn ignition off then on
Press and hold valet switch for 5 seconds
Siren chirps 2 times indicating RF feature program mode.
Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming will be terminated.