Filter
Top Products
128-6794
3 of 12
The Trunk LED will flash 4 times.
The Triggered LED Indicates:
Whenever the system is armed and then triggered from either entry
point or any additional sensor device, the triggered LED will flash 15
times, and the hand held transceiver will play a melody.
Note: Upon trigger, the hand held unit can be selected to vibrate, play a melody,
or both. See details below.
Two Way Transmitter Operation:
The two way transmitter depicted in this manual operates similar to any
transmitter with the exception that it will also indicate that the vehicle acted upon
the command issued.
Locking: Press and release the Lock Icon Button on the transmitter and the unit,
providing it is within range of the vehicle, will lock the vehicle doors and report
back that the command was acted upon by briefly turning on the Lock LED and
beeping once. This lock LED will flash 1 time every 10 seconds until the Unlock
command is issued.
Press and hold for lock button for three seconds causes the unit to go into the
panic mode. See panic mode referenced later on in this manual.
Unlocking: Press and release the Unlock Icon Button on the transmitter and the
unit, providing it is within range of the vehicle, will unlock the vehicle doors and
report back that the command was acted upon by briefly turning on the Unlock
LED and beeping twice. This unlock LED will flash 1 time every 10 seconds
until the lock command is issued.
Press and hold for unlock button for three seconds causes the unit to go into
the car finder mode. See panic mode referenced later on in this manual.
Operating The Trunk Release: When the Trunk transmitter button is operated
for three seconds, if the optional trunk release option is installed, the vehicle's
trunk will open. The Trunk LED will flash 4 times.
NOTE: Must Have Electric Trunk Release.
If this button is operated two times in succession, an optional alternate device
will be activated. Check with your installation to see if either or both these
optional features are installed, and how they are operated.
The Option Button: Press and release the OPT Button on the transmitter and
the unit, providing it is within range of the device it is controlling, will operate the
device. This option button can be programmed into a number of Audiovox
accessories. If the accessory is a second two way Audiovox Remote Start Unit,
perhaps installed in a second vehicle, then the vehicle will act upon the
command but only the prime transmitter for that vehicle will indicate the com-
mand was acted upon.
Toggling Between Vibrate, Chirp, or Both Chirp & Vibrate:
The two way transmitter offers the option of having Beep Tones, Vibration, or
Both Beep Tones & Vibration associated with the function responses of the
transmitter.
To toggle between these modes, press simultaneously the "F" function button