Filter
Top Products
TO ENTER THE PROGRAM MODE:
1. Turn the ignition switch to the “ON” position.
2. Within 10 seconds, Press and release the valet/program switch
three times.
(Siren emits 1 short chirp indicating channel 1 has been entered)
3. Within 10 Seconds, Press and hold the button of the first transmitter
you wish to control the Lock&Arm feature of your security system
until a long chirp is heard from the siren.
(Repeat this for each transmitter you wish to operate the Lock/Arm
feature).
4. Within 10 seconds, press and release the valet program switch one
time.
(Siren emits 2 short chirps indicating channel 2 has been entered)
5. Within 10 Seconds, Press and hold any unused button(s) of the
first transmitter you wish to control the Unlock/Disarm feature of
your security system until a long chirp is heard from the siren.
Note: This channel is used only if you desire separate control of the
Lock/Unlock feature. If you wish to operate the Lock/Unlock
features from a single button, move onto step 6 as whatever
button is programmed into channel 1 will control both Lock &
Arm/Unlock & Disarm.
(Repeat this for each transmitter you wish to operate the Unlock/Dis-
arm feature).
6. Within 10 seconds, press and release the valet program switch one
time.
(Siren emits 3 short chirps indicating channel 3 has been entered)
7. Within 10 Seconds, Press and hold any unused button(s) of the
first transmitter you wish to control Channel 3 output, (Trunk Re-
lease) until a long chirp is heard from the siren.
(Repeat this for each transmitter you wish to operate the Channel 3
output (Trunk Release)
8. Within 10 seconds, press and release the valet program switch one
time.
(Siren emits 4 short chirps indicating channel 4 has been entered)
9. Within 10 Seconds, Press and hold any unused button(s) of the
first transmitter you wish to control Channel 4 output, (Auxiliary
Output 1) until a long chirp is heard from the siren.
2