Filter
Top Products
128-8807
4 of 5
Page 4
will sound). Turn the ignition key on, and press and hold the LED valet switch on. The
alarm will stop sounding, and the vehicle can now be started.
NOTE: Always remember to exit Valet Mode to ensure that the vehicle remains protected at
all times.
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on and off using
the valet push-button switch. To do this...
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the LED valet
push-button switch three times.
3a. If, before proceeding with step 2, the chirps were on, then you will hear 2 chirps to indicate
that the chirps have been turned off.
3b. If, before proceeding with step 2, the chirps were off, then you will hear 1 chirp to indicate
that the chirps have been turned on.
Note: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp intrusion indicator
will always operate. This feature will always warn you if there is a defective sensor
during the arming sequence or if the vehicle had been tampered with in your absence,
even if the normal arming and disarming chirps have been turn off.
REMOTE PANIC OPERATION:
The Lock and Unlock buttons on your keychain transmitter also functions as a "panic" switch
for instant activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more.
The alarm will immediately sound.
2. To stop the alarm, press and release the Trunk/Key button on the keychain transmitter.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
CAUTION! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
TRUNK RELEASE:
This security system has an additional feature that can be wired to a number of different
optional accessories. Some of the more common uses for this "channel" are:
Remote Trunk Release - available for any vehicle with factory installed electronic
push-button trunk release.
Remote Car Starter - available for most automatic transmission, fuel injected vehicles.
Remote Window Roll Up - available for most vehicles equipped with power windows.
To activate the optional accessory:
Press and hold the Trunk/Key button on the keychain transmitter for approximately
3 seconds. If the system has been programmed differently by your installation center,
this output may be accessed by pressing buttons 1&2 simultaneously for 3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".