Filter
Top Products
7
preventative. Route the camera cable connector through the hole and insert the
grommet into the hole to prevent water from entering into the vehicle.
3. Place the camera bracket behind the license plate and line up the holes. Fasten the
camera mounting bracket and the license plate to the vehicle using the anti-theft
screws provided. After installation of screws with the tool provided, place the tool in
the glove compartment or other safe place for future use.
4. Wire the Camera to the vehicle’s reverse lamp.
a) Locate the reverse lamp in the tail light assembly. Using the tap connector
supplied, perform the following steps:
i. Place the un-stripped positive lead wire on the run channel.
ii. Insert the un-stripped red power wire completely.
iii. Fold the tap connector back over the wires and make the connection by
crimping the u-contact down flush with the plastic insulator.