Filter
Top Products
3
I. PREPARATION OF VEHICLE INTERIOR
1. Remove and retain (3) three screws which
secure rear driver’s side seat track in place.
2. Slide rear seat forward and remove and retain
seat track. See Figure 1.
3. Mark wire location as shown in Figure1 and
drill a 1" hole in plastic panel. Caution: Before
drilling, check for wiring or other
componentry behind panel. Drill only where
indicated.
4. Install and route all video and audio cables, and
any other added component requirements to their
respective places in the vehicle. Refer to
component installation instructions for wiring
diagrams. The suggested routing of the video
system cable is as follows: Above the headliner
from video system to C-pillar. Down the C-pillar
to the floor. Route the power lead to a fused
accessory controlled source. Connect the ground
lead to the vehicle chassis. Route the remaining
wiring (RCA plugs, Remote Sensor extension,
etc.) to the VCP location. See Figure 2. Connect
per instructions included with the video system.
If video system if to be used as a television,
install an appropriate antenna per instructions
included with the antenna.
II. INSTALLATION OF HOUSING
5. Make (3) three cuts and fold carpet as shown in Figure 3.
FIGURE 1
FIGURE 2
FIGURE 3