Filter
Top Products
128-8601
5 of 8
Page 5
PROGRAMMING TRANSMITTERS:
At times it may become necessary to program replacement or additional transmitters for
use with your system. To do this:
1) With the system unlocked or disarmed, turn the ignition key to the on position.
2) Press and release the Program/Override push-button switch three times
The unit will flash the parking lights and or beep the horn once to indicate that the system
is in the transmitter program mode. The LED will also flash one time pause, one time
pause, etc... indicating that you are in the transmitter program mode of the unit’s channel 1
or single button program mode.
3) Press and hold the lock button of each additional transmitter you wish to operate your
system.
NOTE: The unit is capable of storing up to 4 transmitters. If a fifth transmitter is added, the
first transmitter programmed will be bumped out. This unit will also program all 4 buttons of
your transmitter when the lock button is operated while in the program mode. Once all
transmitter have been programmed, turn the ignition switch off to exit the program mode.
If you require priority programming for multiple vehicle operation please read on.
The system allows priority button programming in case you intend to operate two vehicle
with one transmitter. In this instance you will program the default button combination,
(One Button Programming), for the main vehicle you drive, and a different combination for
the second vehicle so you are not unlocking, locking, or starting both vehicles when they
are within range of each other.
To prioritize transmitters after programming the transmitter into the first vehicle:
Enter the transmitter program of the second vehicle as above by:
1) With the system unlocked or disarmed, turn the ignition key to the on position.
2) Press and release the push-button switch three times
The unit will flash the parking lights and or beep the horn once to indicate that the system
is in the transmitter program mode. The LED will also flash one time pause, one time
pause, etc... indicating that you are in the transmitter program mode of the unit’s channel 1
or single button program mode.
3) Press and hold any combination of buttons of your transmitter that was not used for
your primary vehicle.
If, for instance you can press & hold the lock & unlock buttons simultaneously, for
controlling Lock function of the second vehicle.
4) Press and release the program push-button switch once to advance to channel 2,
unlock.
Here you can press and hold the lock & start buttons simultaneously, for controlling the
unlock function of the second vehicle.
5) Press and release the program push-button switch once to advance to channel 3,
start.
Here you can press and hold the start & option buttons simultaneously, for controlling the
start function of the second vehicle.