Filter
Top Products
128-7852A
7 of 10
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a
chirp, then release and immediately press the same button a second time until you hear a long chirp
followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information below will
successfully remove the transmitter.
NOTE: For this procedure, you must have all transmitters you wish to remain programmed in your system
available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock function of your unit
making sure you occupy all 4 transmitter slots. In other words, you have three transmitters you wish to
remain programmed. Press and hold the lock button of transmitter one until a long chirp is heard, then
press and hold the lock button of transmitter two, then press and hold the lock button of transmitter three,
followed by pressing and holding the lock button of transmitter one again. This action fills all 4 receiver
slots.
3) Advance to receiver channel 2 by pressing the pushbutton switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate the unlock function of your
vehicle, again making sure all 4 transmitter slots are filled.
4) Advance to receiver channel 3 by pressing the pushbutton switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate the start function of your
vehicle, again making sure all 4 transmitter slots are filled.
If you are uncomfortable about the programming of additional transmitters as outlined in the processes
above please contact your installation center or call the technical service number listed on the back of the
transmitter for help.
BATTERY REPLACEMENT
The transmitter incorporates a small LED visible through the case which is used to indicate battery condi-
tion. You will notice a decrease in transmitter range as the battery condition deteriorates. Transmitter
battery replacement is recommended at least every 10 to 12 months, depending upon how frequently the
transmitter is used.
To replace the battery in the APS620TX:
1) Remove the small # 0 Phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying attention to the proper polarity orienta-
tion.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the case, then reinstall the small case screw removed in step 1.
5) If you accidently dislodge the circuit board from the transmitter housing, be certain that the rubber mem-
brane is seated properly, and the buttons are properly exposed from the front view of the case, then
insert the circuit board, and return to step #4.
APS620TX Uses GP23 Battery
To replace the battery in the APS920TX there is a slide off battery cover on the rear of the transmitter. Lift the
edge of the door slightly and slide the cover off. Remove the discharged AAA battery and replace with a
fresh one, then replace the battery cover.
APS920TX2 Uses AAA Battery
FEATURES AND FUNCTIONS OF YOUR TWO WAY LCD APS920TX2
Doors are locked Icon. If the system is armed also “ “ will appear below the Lock Icon.
Doors Unlocked Icon.
Valet Mode.
When Transmitting, any button activated.
Within Range Indicator.
Timed Start Activated.
Someone Paging You From Your Vehicle.
Vibrate Mode Is On. Toggle feature on and off by pressing Trunk/Key + * buttons for 5 seconds until
beep is heard, then press the Unlock Button Once.