Filter
Top Products
128-7828A
3 of 4
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your
system. To remove a transmitter that has been programmed in your system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a
chirp, then release and immediately press the same button a second time until you hear a long chirp
followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information below will
successfully remove the transmitter.
NOTE: For this procedure, you must have all transmitters you wish to remain programmed in your system
available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock function of your unit
making sure you occupy all 4 transmitter slots. In other words, you have three transmitters you wish to
remain programmed. Press and hold the lock button of transmitter one until a long chirp is heard, then
press and hold the lock button of transmitter two, then press and hold the lock button of transmitter three,
followed by pressing and holding the lock button of transmitter one again. This action fills all 4 receiver
slots.
3) Advance to receiver channel 2 by pressing the push-button switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate the unlock function of your
vehicle, again making sure all 4 transmitter slots are filled.
4) Advance to receiver channel 3 by pressing the push-button switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate the start function of your
vehicle, again making sure all 4 transmitter slots are filled.
If you are uncomfortable about the programming of additional transmitters as outlined in the processes
above please contact your installation center or call the technical service number listed on the back of the
transmitter for help.
BATTERY REPLACEMENT
The transmitter incorporates a small LED visible through the case which is used to indicate battery condition.
You will notice a decrease in transmitter range as the battery condition deteriorates. Transmitter battery
replacement is recommended at least every 10 to 12 months, depending upon how frequently the transmitter
is used.
To replace the battery in the 620TX:
1) Remove the small # 0 Phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the case, then reinstall the small case screw removed in step 1.
5) If you accidently dislodge the circuit board from the transmitter housing, be certain that the rubber mem-
brane is seated properly, and the buttons are properly exposed from the front view of the case, then insert
the circuit board, and return to step #4.
APS620TX Uses GP23 Battery
CAUTION!!
CARBON MONOXIDE GAS CAN CAUSE SERIOUS INJURY AND EVEN DEATH!
It is the sole responsibility of the user to operate the vehicle this system is installed in a
safe manner.
This device must not be used in an enclosed space like a garage, attached or detached,
car port, or any partially enclosed areas. Also this device must be placed in the service
mode when dropping the vehicle off for service to prevent injury to the service
technician.