Filter
Top Products
the
rearview mirror onto the existing mirror from one side with one fixed
belt. Then fasten the other belt on the other side of the mirror. To
prevent the mirror from falling off, tighten the belts until secure to the
factory rearview mirror on both sides.
Figure 3
d) Cut off excess part of straps.
(2) Wiring the System.
1. RED FUSED WIRE: +12 VDC ACCESSORY SOURCE
Connect this wire to a source that is 12 volts when the Ignition key switch
is turned on, and 0 volts when the ignition key switch is turned off.
2. BLACK WIRE: CHASSIC GROUND
Connect this wire to a solid, metal part of the vehicle’s chassis.
3. YELLOW WIRE: GROUND WHEN PARKING BRAKE IS
APPLIED
Connect this wire to the wire from the parking brake that turns on the
parking brake light on the dash. This wire will have voltage on it while the
Ignition key switch is turned on and 0 volts when the parking brake is
pressed.
(3) Connect the mirror cables adapter and power cable follows the fig.7
illustration for connection.
2. Signal Inputs
The signal input connections for the system include:
(1) Rear Camera: By connecting rear camera with 4 pin connector at the