Filter
Top Products
128-4633B
6 OF 27
Page 6
The alarm system will stop sounding and enter the valet, (by-passed) mode. This is indi-
cated by the dash mounted LED turning on. You can now start and operate the vehicle
normally.
Typically this override mode is used only if the transmitter has become inoperative. After
repair or replacement of the transmitter, returning the system to the full operation mode is
necessary. To do so, see item 3 under the heading VALET SWITCH.
PROGRAMMING THE CUSTOM CODE MANUAL OVERRIDE
Your Security System can be disarmed without the use of the keychain transmitter. This is
necessary, since you will need the ability to disarm the system if you lose your transmitter,
or if the transmitter battery fails.
If your system has been selected for Custom Code manual override as indicated on the last
page of this manual, in order to provide the highest level of security, this system will allow
you to program your personal manual override code. This code is a ( 2 ) digit code. The first
digit must be a digit from 1 through 9, and the second digit must be either 1, 2, or 3.
To program your access code, the security system must be in the disarmed state. Once
disarmed, program your code as follows;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will
sound one short chirp, followed by one long chirp. This indicates that the sys-
tem is in the manual override programming mode.
3. The red dash L.E.D. will begin to count by flashing. Allow the L.E.D. to flash until it
gets to the first digit of your selected code.
4. As soon as the L.E.D. turns on for the corresponding number of your first digit,
quickly turn the ignition key;
1. off then on for second digit 1
2. off then on twice for second digit 2
3. off then on three times for second digit 3.
5. The siren will sound one short chirp, followed by one long chirp, indicating that the
code has been memorized.
6. After a 2 second pause, the L.E.D. will flash confirmation of the stored code, begin-
ning with the first digit, then a pause, then the second digit.
EXAMPLE : To program the manual override code 52, you would;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will sound
one short chirp, followed by one long chirp. This indicates that the system is in
the manual override programming mode.