Filter
Top Products
Transmitter functions
The system uses a computer-based learn routine to learn the transmitter buttons. This makes it
possible to assign any transmitter button to any system function. The transmitter initially comes
programmed with Standard Configuration, but may also be customized by an authorized dealer.
The buttons in all of the instructions in this manual correspond to a Standard Configuration
transmitter.
STANDARD CONFIGURATION
Button
Pressing
duration
Action Confirmations
1 sec.
The arming, locking and Panic mode Disengaging
functions are controlled by pressing this button for one second.
Parking lights flashes
once. Horn honks once
on every commands.
5 sec. The panic mode engages when this button is depressed for at least 5 seconds.
Panic mode engages.
1 sec.
The disarming, unlocking and Panic mode Disengaging
functions are controlled by pressing this button for one second.
Parking lights flashes
twice. Horn honks twice
on every commands.
5 sec. The panic mode engages when this button is depressed for at least 5 seconds.
Panic mode engages.
1 sec.
Silent Mode™ works by pressing this button for
less than one second before arming or disarming.
No confirmations.
1.5 sec.
An optional auxiliary function, such as trunk release,
can be controlled by pressing this button for 1.5 seconds.
Parking lights flashes three
times. Horn honks three
times on every commands.
The auxiliary output controls : Note down which auxiliary function is associated to this command.
1 sec.
An optional auxiliary convenience or expansion function that you have added
to your system can be activated by pressing these buttons simultaneously.
Flash one time.
&
The auxiliary output controls : Note down which auxiliary function is associated to this command.
Using your system
The buttons used in the instructions in this manual correspond to the standard configuration.
Remember, this is not the only way your transmitter may be set up. It can be custom configured
to meet your needs.
ACTIVE ARMING
You can activate, or arm, the system by pressing on your transmitter for one second. When the
system arms, you will hear a short siren sound, or chirp, and the parking lights will flash once. If
the vehicle’s power door locks have been connected to the system, the doors will lock.
While the system is armed, the status LED will flash approximately once per second, indicating
that the system is actively protecting your vehicle. If you hear a second chirp after arming, and see
the status LED flashing in groups, refer to the Diagnostics section of this guide. This extra chirp is
called Bypass Notification.
© 2006 ASTROFLEX ELECTRONICS – ALL RIGHTS RESERVED 2