Filter
Top Products
6
ENGINE RUNTIME
Your engine will stop automatically after a preset time of 2 min. , 4 min. , 8 min. or 18 min.
depending
on
settings during installation. Runtime doubles for diesel engine vehicles.
Parking lights will stay on as long as engine is running.
TRIGGER INPUT
Your remote starter is equipped with a negative trigger (pulse) input.
This input can be connected to another remote control device or to an AstroStart RTS-2
timer output (optional), part no. 310-903-502.
If this input is connected, consult this device's manual or ask your technician which
command controls the Start/Stop function.
The Start/Stop commands received on this input are ignored while the engine is running on a
remote start.
All Start/Stop functions controlled by this input behave in the same way as functions controlled by remote.
CONTINUOUS MODE (RS-613 – RS- 711XR ONLY)
The “Continuous Mode“ function allows to remove the key from the ignition while leaving the engine running. This convenient
feature allows you to leave the vehicle for short periods of time while the climate controls remain on.
AUTOMATIC
TRANSMISSION
VEHICLES
To access Continuous Mode, send start command
while engine is idling. Parking lights, engine and preset accessories
will remain on for the duration of the programmed runtime.
MANUAL
TRANSMISSION
VEHICLES
To access Continuous Mode, send start command before removing the
key from ignition when performing the safety sequence described on page 3.
Note: Do not send the STOP command if you perform
sequence activated by the remote control (Step 6).
Remove key, exit vehicle and lock doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to the RUN position and depress brake pedal.
WHAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
ignition switch is in the RUN position (prevents starting);
remote control sends a Stop command;
hood is open;
brakes are applied;
engine is over-revving (available on model RS-711XR only);
main switch is OFF;
safety sequence not valid (manual transmission vehicle only - parking brake not applied, opening of door detected
while remote starter was not keeping engine running).
M
AIN SWITCH
The main switch is usually mounted under the dashboard. It is a toggle ON/OFF switch that
is used to cancel start functions.
It does not disable other commands which remain active (lock/unlock commands, etc.).