AstroStart 801 Remote Starter User Manual


 
8
UNLOCK
Press the
button. Doors are unlocked and parking light flashes twice to confirm command has been received.
The “Unlock“ function can be programmed and connected in such a way that the first Unlock command only unlocks the
driver's door, while a following Unlock command unlocks the other door(s).
Dome light will turn on for 30 seconds every time (optional connection during installation):
Unlock command is sent.
Engine is stopped (ignition switch).
Continuous mode is activated.
This 30-second duration is cancelled when Lock command or Trunk command is sent, brakes are applied or key is inserted
in ignition and turned to RUN position.
TRUNK RELEASE
Press the and buttons simultaneously (lights: 3). Trunk is released and parking lights flash three times to confirm
command has been received.
The trunk cannot be released if ignition key is in RUN position. In this case, parking lights flash once to confirm that
command has been received but trunk could not be released.
If you are not sure you have received confirmation, repeat command. System will repeat confirmation as often as you wish.
If your vehicle is equipped with a factory installed security system and that this system is neutralized by the trunk release
command, remember to rearm it after trunk is closed ("Lock" command).
AUTOMATIC LOCK/UNLOCK
Programmable as Active or Inactive during installation.
This function locks the doors when ignition key is in RUN position, engine is running and brakes are applied. Doors are
unlocked when key is turned from RUN to OFF or when Continuous Mode is activated.
If “Unlock“ function is set to unlock only driver's door on the first command, the “Automatic Unlock“ function will unlock
driver's door only. If dome light is connected to system, it is activated when an automatic unlock occurs.
This function is : Active
Inactive
.
ANTITHEFT (CIRCUIT DISABLER)
(Option 2 only )
Programmable as Active
or Inactive
during installation.
Your Remote Starter is equipped with an antitheft system. This system, when enabled, consists of an output that controls a
relay that cuts all circuits required to operate your vehicle (optional connection).
There are two types of antitheft systems.
“PASSIVE ARMING” TYPE ANTITHEFT
This type of Antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one
minute. It can also be armed manually by sending a “Lock” command (unless ignition key is in RUN position).
DISARMING
Antitheft system is disarmed for one minute when you send “Unlock” command.
If the ignition key is not turned to RUN position within one minute, system automatically rearms, thus preventing any intruder
from starting your vehicle, even with the key in the ignition switch.
“ACTIVE” TYPE ANTITHEFT
This type of Antitheft system arms by sending the “Lock” command (unless ignition key is in RUN position) and disarms by
sending the "Unlock" command.