Filter
Top Products
17
“P
ASSIVE ARMING" TYPE ANTITHEFT /
This type of antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one
minute. It can also be armed manually by sending a Lock command (unless ignition key is in RUN position).
DISARMING
Antitheft system is disarmed for one minute when you send an Unlock command. If ignition key is not turned to RUN
position within one minute, system automatically rearms, thus preventing an intruder from starting your vehicle, even with
ignition key.
It can be connected so that horn sounds if an intruder tries to start your vehicle when antitheft is armed.
“ACTIVE" TYPE ANTITHEFT /
This type of antitheft system is armed by sending a Lock command (unless ignition key is in RUN position) and is disarmed
by sending an Unlock command.
VALET MODE (Antitheft)
The Antitheft function can be deactivated for the same reasons and in the same way as the Antitheft system. See "Valet
mode" details on page 14.
UTILITY COMMANDS
These commands allow you to control most of the vehicle accessories depending on what was connected during installation
(headlights, defroster, etc.). For more information, check with your technician.
To activate these functions, simultaneously press the buttons as shown in the following table.
The accessory associated to each of these commands is activated for the duration set at time of installation.
The delay can be canceled by repeating the command.
CAR FINDER
Press and buttons simultaneously.
This function sounds the horn (short melody) and flashes the parking lights so you can locate your vehicle in a large
parking lot.
REMOTE SILENT MODE
The remote can be programmed to be used in silent mode.
Refer to the following table to select the necessary command.
The mode is de/activated the same way (except for the alarm and the pre-shock).
KEYPAD LOCK
The keypad of your remote can be locked to prevent any unwanted commands to be sent
to your vehicle.
The mode is de/activated the same way.
Refer to the following table to select the necessary command.
Remote control
Commands
4-button 5-button 6-button
Corresponding accessory Duration
UTILITY 1
UTILITY 2
-
UTILITY 3
- -
UTILITY 4
- -
Remote controls
4-button 5-button
> 5 sec.
Remote controls
4-button 5-button
> 5 sec.