AstroStart 2106U Remote Starter User Manual


 
15
OTHER COMMANDS
ANTITHEFT (CIRCUIT DISABLER)
Programmable as Active or Inactive during installation.
Your Remote Starter is equipped with an Antitheft system. This system consists of an output that controls a relay that cuts all
circuits required to operate your vehicle (optional connection).
“PASSIVE ARMING» TYPE ANTITHEFT /
This type of Antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one
minute. It can also be armed manually by sending a “Lock” command (unless ignition key is in RUN position).
DISARMING :
Antitheft system is disarmed for one minute when you send “Unlock” command.
If ignition key is not turned to RUN position within one minute, system automatically rearms, thus preventing any intruder
from starting your vehicle, even with ignition key.
It can be connected so that horn sounds if an intruder tries to start your vehicle when it is in the active state.
“ACTIVE» TYPE ANTITHEFT /
This type of Antitheft system arms by sending the “Lock” command (unless ignition key is in RUN position) and disarms by
sending the "Unlock" command.
VALET MODE (ANTITHEFT)
(6-button remote)
The antitheft function can be deactivated for the same reasons and in the same way as the Antitheft system. See "Valet
mode" details on page 15.
UTILITY COMMANDS
These commands allows you to control most of the vehicle accessories depending on what was connected during
installation (headlights, defroster, etc.). For more information, check with your technician.
To activate these functions, simultaneously press the buttons as shown in the following table.
The accessory associated to each of these commands is activated for the duration set at the installation.
The delay can be cancelled by repeating the command.
CAR FINDER
Press and buttons simultaneously (lights: 3, horn: 7). This function sounds horn (short tune) and flashes parking
lights to help you locate your vehicle in a large parking lot.
PANIC
(6-button remote)
Press
button. This command activates parking lights, siren, horn, and dome light intermittently, depending on which
is connected to system, for 30 seconds
or 60 seconds
depending on programming during installation.
Panic mode is used to attract attention if you are in difficulties.
This command will not be executed if engine is kept running by ignition key. In this case, parking lights will flash once to
confirm that command has been received.
Use the stop command to abort panic mode or depress brake pedal.
Commands Buttons Corresponding accessories Duration
UTILITY 1
UTILITY 2
UTILITY 3
UTILITY 4