Filter
Top Products
Owners Guide
Self Learning Shock Sensor
1. Press & release the button.
2. The Park lights will flash and the siren will chirp once.
3. When the vehicle has started, the system will flash the park lights four times and
then remain “On” while the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
Extended Runtime
1. Press & release the button while the vehicle is running.
2. The system will respond with a park light flash and siren chirp to confirm the runtime
has been Extended. The system will reset to the default runtime, (normally 15 minutes).
Remote Start
Reservation Mode - Manual Transmission Models Only
3 sec.
Remote Stop
1. Press and hold the button for three seconds. The remote starter will shut down.
2. The park lights will flash two times and the siren will chirp two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
Idle Mode
1. While the vehicle is running with key, press the button.
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key “off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Lock the
door while the vehicle is left running.
While
running
Press &
Release
REMOTE STARTER FEATURES
Diagnostics
1st
2nd-6 sec.
3
1) Press the LOCK button on the remote five times in a row, the siren should chirp three times and
the park lights should turn On and remain On while in Learn Mode..
2) While the park lights are On, strike the vehicle with a sharp impact at the force to trigger the alarm.
3) The system will respond with one siren chirp to confirm the impact has been learned. To exit Learn Mode, press the lock
or unlock button on the remote transmitter.
PARK LIGHTS STATUS LED DIAGNOSTIC CODE
3 Flashes Series of 3 Flashes Door Opened “M” Models
4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” units
5 Flashes Series of 5 Flashes Hood Pin Grounded (Open)
6 Flashes Series of 6 Flashes Brake Pedal Shutdown
7 Flashes Series of 7 Flashes Tach Lock-Out
8 Flashes Series of 8 Flashes 3 Start Attempts with no start
1. With the vehicle running, apply the park brake then press & release the brake pedal.
2. The park lights will flash to confirm that reservation mode has been activated.
3. Remove key from Ignition, and exit the vehicle. (the vehicle will remain running)
4. *Close the door and the vehicle will shut off.
*If the vehicle has a delay dome-light, the vehicle may run until the dome-light turns off.
5) The vehicle is know in Reservation Mode and may be remote started.
Note: Opening a door after this point will cancel Reservation Mode.
Timer / Optional Temp Start
1.Press & release the # button, then press and hold the button for six seconds, until the
parking lights turn “on”.
2. While the parking lights are “on” the start cycle can be selected.
1 hour cycle or 0C Press LOCK button 1 flash
2 hour cycle or -5C Press UNLOCK button 2 flashes
3 hour cycle or -15c Press button 3 flashes
4 hour cycle or -25c Press button 4 flashes
3. System will start vehicle at selected cycle for up to 24 hours.
4. The temp start must have the temp sensor installed and will only trigger 1 time each 2
hours if the sensor is not installed the unit will activate the timer mode.
TO CANCEL COLD START MODE
1. Press & release the # button, then press and hold the button for four seconds.
2. The park lights will flash and the siren will chirp twice.
#