Ultra Start 1350 Remote Starter User Manual


 
1. Press & release the button.
2. The Park lights will flash one time and the horn(optional) will honk one time.
3. When the vehicle has started, the system will flash the park lights four times and then
remain “on” while the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
1. Press & release the button while the vehicle is running.
2. The system will respond with one park light flash and one horn honk (optional) to
confirm Extended Runtime. The system will reset the run time, (normally 15 minutes).
1. Press and hold the # button for two seconds.
2. The system will flash the park lights and honk the horn(optional) five times.
3. This feature can help find your vehicle in a crowded parking lot.
1. Press and hold the UNLOCK button for three seconds.
2. The doors will unlock, continue holding the unlock button for three more seconds, the trunk
release will then activate. The trunk release will be confirmed by one park light flash.
Note: The trunk release output will not activate when the ignition key is in the “On” position.
1. Press & release the LOCK button on the remote transmitter.
2. The park lights will flash and the horn (optional) will honk one time.
3. The doors will lock.
4. The LED will start flashing within five seconds.
1. Press & release the UNLOCK button on the remote transmitter.
2. The park lights will flash and the horn (optional) will honk two times.
3. The doors will unlock.
4. The LED will stop flashing.
1. Press & hold the LOCK button for three seconds.
2. The park lights will flash and horn will honk (optional)
PANIC MODE DISABLE
- Press LOCK button to disable the panic mode and to lock the doors.
- Press UNLOCK button to disable the panic mode and unlock the doors.
- Panic Mode will stay activated until disabled by the remote transmitter.
1. Press & release the LOCK & UNLOCK buttons at the same time.
2. If the doors are locked this will unlock the doors without horn honks, the park lights will
flash two times to confirm the doors have unlocked.
3. If the doors are unlocked this will lock the doors without horn honks, the park lights will flash
one time to confirm they have locked.
Lock Doors
Reservation Mode - Manual Transmission Models Only
Remote Start
Extended Run Time
Remote Stop
Idle Mode
Unlock Doors
Silent Lock And Unlock
Trunk Release
Car Finder Mode
Panic Mode
1. Press and hold the button for three seconds. The remote starter will shut down.
2. The park lights will flash two times and the horn(optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
1. While the vehicle is running with key, press the button.
2. The park lights will turn on and the horn(optional) will honk once.
3. Turn the ignition key “off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Lock the door
while the vehicle is left running.
Press Once to Lock the doors. (Hold For Panic Mode)
Press 2nd Time & Hold for Constant Lock Output
Press Once to Unlock the doors.
Press & Hold for Trunk / Aux Output
Press Once for Start -(2 Times if programmed for Safety Start)
Press & Hold for 3 seconds to turn off the remote starter.
Press & Release then press START and hold for Timer Mode
2nd Car Operation
Press the # button at the same time as the command for the second car. This feature
requires special programming from the dealer.
Diagnostics
TO INSURE SAFE STARTING OF MANUAL TRANSMISSION VEHICLES
1. With the vehicle running, apply the park brake then press & release the brake pedal.
2. The park lights will flash to confirm that reservation mode has been activated.
3. Remove key from ignition, and exit the vehicle. (vehicle will remain running)
4. The vehicle will shut off when the door is closed.
(If your vehicle has a delay dome-light, the vehicle may run until the dome-light turns off)
VEHICLE IS NOW IN RESERVATION MODE AND MAY BE REMOTE STARTED
NOTE: OPENING A DOOR WILL CANCEL RESERVATION MODE
Turbo Timer Mode
1. While the vehicle is running with key, press the # button.
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key “off” and the vehicle will continue to run for 2 minutes
While
running
PARK LIGHTS STATUS LED DIAGNOSTIC CODE
3 Flashes Series of 3 Flashes Door Opened “M” Models
3 Slow Flashes LED’s On Solid System Is In Service Mode
4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” units
5 Flashes Series of 5 Flashes Brake Pedal Shutdown
5 Slow Flashes Series of 5 Flashes Ignition On During Start Attempt
6 Flashes Series of 6 Flashes Hood Pin Grounded
7 Flashes Series of 7 Flashes Tach Lock-Out
8 Flashes Series of 8 Flashes 3 Start Attempts With No Start
2
3
1. To enter the Cold Start Timer Mode, Press and release the # button, then press and hold the
Start button for 4 seconds until park lights turn “On”.
2. While the parking lights are “on” the start cycle can be selected.
- 1 hour start cycle Press LOCK button 1 Park light flash
- 2 hour start cycle Press UNLOCK button 2 Park light flashes
- 3 hour start cycle Press START button 3 Park light flashes
- 4 hour start cycle Press # button 4 Park light flashes
TO CANCEL TIMER START MODE
1. Press & release the # button, then press and hold the Start button for six seconds.
2. The System will respond with two flashes and two horn honks (optional).
Note: For safety reasons Timer and Temp Mode will be cancel if started with the key or by
remote. LOW TEMP MODE NOTE: Activating any of these modes with the optional temperature
sensor connected will automatically activate LOW TEMP MODE.
Timer Mode Or Temperature Sensor