Ultra Start 1172 Remote Starter User Manual


 
PAGE 4
1172 SERIES
OWNER'S MANUAL
SYSTEM OPERATIONS
1. Press and release the START button on the remote transmitter one time.*
*Press twice if the system is programmed for Safety Start.
2. The park lights will flash and the horn (optional) will Honk once as confirmation.
3. The vehicle will remote start and the park lights will turn on and remain on while
the vehicle is running under remote start**.
- If the remote start fails to start see the diagnostics chart at the back of the manual.
**DEFAULT RUNTIME OF THE SYSTEM IS 15 MINUTES.
Once the vehicle is remote started and you wish to enter the vehicle to drive away
you must preform the following steps.
1. Enter the vehicle then insert the key into the ignition switch.
2. Turn the key forward to the ON or RUN* position. (This is usually 2-3 key
positions)
*Do not turn the key to the start position.
3. Step on the brake and the remote starter will turn off however the vehicle will
continue to run because the key is on. If the key is not in the on position when the
brake is pressed the remote starter and the vehicle will both shut off.**
** If the vehicle shuts down simply restart the engine with the key.
DO NOT TURN THE KEY TO THE START POSITION WHILE THE ENGINE IS
RUNNING.
REMOTE STARTER ACTIVATION
PRESS & RELEASE
KEY TAKEOVER
TURN KEY ON
PAGE 5
1172 SERIES
OWNER'S MANUAL
SYSTEM OPERATIONS
1. While the vehicle is running with the remote starter press and hold the START
button for three seconds.
2. The park lights will flash and the horn (optional) will honk 2 times to confirm
shutdown.
- Pressing the brake pedal or opening the hood will also shut down the remote starter.
THE VEHICLE WILL SHUT OFF WHEN THE RUNTIME EXPIRES (DEFAULT
This feature allows the user to safely leave the vehicle running without leaving the
keys in the ignition.
While the vehicle is running with the key press and release the START button then
remove the key from the ignition. The vehicle will run for 15 minute while you are
away. When re-entering the vehicle follow the key take over procedure.
1. While the vehicle is running with the remote starter, press and release the START
button.
2. The park lights will flash and the horn (optional) will honk one time as confirmation.
The system will reset the run time (See Example Below)**.
**Not available with 4 minute run time.
Example- If the vehicle has been remote started for 10 minutes and you press and
release the start button the system will run for a addition 15 minutes totalling 25
minutes of runtime.
REMOTE STARTER SHUT DOWN
PRESS & HOLD
ENGINE IDLE MODE
PRESS & RELEASE
EXTENDED RUNTIME
PRESS & RELEASE