Filter
Top Products
User-Programmable Features
All system and remote control programmable features are accomplished by
turning the ignition key “ON” (or starting the engine) and flicking the valet
switch on and off a preset number of times.
Your system also allows you to add new remote controls in one step, delete
lost or stolen remote controls or rearrange the factory preset remote control
functions.
1. Remove the system from Protected Valet Mode. Programming cannot be
accessed while the system is in Protected Valet Mode indicated by the
LED on solid red.
2. Select the feature you wish to program from the “Programming Table for
System Features” or the “Programming Table for Remote Controls” on
page 9. Note the number of chirps associated with that feature.
3. Turn the ignition key to the “ON” position.
4. Within 10 seconds, begin flicking the valet switch on and off. The siren
will chirp once each time you flick the switch on then off.
5. Continue flicking the switch on and off, counting the number of chirps.
NOTE: Stop when you reach the number of chirps associated with your
chosen feature.
6. Follow the “Secondary Action.” You will hear a number of chirps to
confirm that you have changed the setting of that feature.
7. Turn the ignition key to the “OFF” position.
8. Repeat steps 1-7 for any other feature you wish to program.
8
AMX78(3) Owner's Manual 0399