Agri-Fab 45-04731 Automobile Accessories User Manual


  Open as PDF
of 24
 
7
FIGURE 9
FIGURE 10
USING THE SMARTLINK PLATFORM
ATTACHING TOOLS - CENTER BRACE
Depending on which tool is used, the center brace may
need to be moved to either the center or top of the
Smartlink Platform.
ATTACHING TOOLS - LOADING TOOLS
Different tools should be attached in the ways outlined
below to lower risk of injury. Always exercise caution
when loading a tool into the platform.
PRE-ASSEMBLED BOLT
ROLLER AND DETHATCHER
PRE-ASSEMBLED BOLT
SPIKE AND PLUG AERATOR
For roller and dethatcher tools, the center 1.
brace should be attached to the top of the
SmartlinkPlatformasshowningure9.Tighten.
For spike and plug aerator tools, the center 2.
brace should be attached to the middle of the
SmartlinkPlatformasshowningure10.Do not
tighten yet.
FIGURE 11
FIGURE 12
SPIKER/PLUGGER
Slide the bushings on each end of the tool into the 1.
axle retainers one end at a time. Make sure the axle
retainerssnapintothelockposition.Seegure11.
ProceedtoLOCKINGTOOLSsectiononpage8.2.
ROLLER
Fill roller with water then insert and lock roller plug.1.
Position platform over roller.2.
Unlock lift handle and lower platform until axle 3.
retainers lock onto bushings.
ProceedtoLOCKINGTOOLSsectiononpage8.4.
 previous next