Filter
Top Products
Y1-03-0244B 28
APPENDIX E - USER INTERFACE: DIGITAL DISPLAY DURING EXTENDED
GPS TEST
The following chart describes the display and audio-visual feedback the beacon
provides during extended GPS Test. The messages on the digital display
typically appear as one or two words at a time, until the entire message has
been displayed.
AquaLink™ View and SARLink™ View display, LED/ Audio Signaling
and Description of Operation
The system informs you that the extended GPS test has initiated.
The system reminds you that GPS data acquisition is optimized by giving the beacon a
clear view of the sky.
The system informs you that the beacon is in the process of performing the extended
GPS test. This message repeats for approximately 100 seconds while the GPS is
acquiring data.
The system informs you that the beacon has passed the extended GPS test.
The system provides the user with the GPS coordinates acquired during a successful
test. Coordinates will scroll from right-to left.
The system informs you that the beacon has failed the extended GPS test after 10
minutes.
This message appears if extended GPS test failed. The system advises you to refer to
this Product Support Manual (User Book) for information on what to do and who to
contact.
The system informs you that the extended test is complete, and that the system is
entering shut down.
LONG
GPS
DATA
TEST
START
GIVE
CLEAR
VIEW
TO
SKY
GPS
TEST
SEE
USER
BOOK
TEST
END
LT: 26.03.033N LG: 80.10.066W
GPS
TEST √
G
NO
GPS
R