Filter
Top Products
Lit. No. B64090, Rev. 00 31 April 1, 2006
4. Return to the interior of the vehicle. Test the
remaining functions of the snowplow. The system
power on the control should be in the "ON"
position. Raise the plow to its maximum height by
pulling the joystick back (or down) or pressing the
"U" button on the touchpad. Angle the snowplow to
the left by moving the joystick toward the "L" (left
angle) on the label or pressing the "L" button on
the touchpad. If the plow function is slow or
delayed, the hydraulic fluid is filling the cylinder
and replacing the air in the system. Test the
remaining functions of the snowplow. To lower the
plow to the ground, push the joystick ahead (or
up) or push the "D" button on the touchpad.
NOTE: The float function is activated when the
joystick is pushed ahead (or up) into the "lower"
position or the "D" button is pressed on the
touchpad and held there for an additional .5 sec
after the blade contacts the ground. The LED float
light (touchpad only) will come on when the
snowplow is in float mode.
Angle the snowplow to the right by moving the
joystick toward the "R" (right angle) on the label or
pressing the "R" button on the touchpad. Check
the fluid level in the reservoir and fill to 3/4" from
the top of the tank if needed.
5. Check for oil leaks around the manifold, pump,
hydraulic hoses and all cylinders. If there are any
leaks, turn off the power switch on the control and
shut off the vehicle engine. Then, tighten any
loose connections and/or fittings. Restart the
vehicle, cycle all blade controls, then check to see
if all the leaks have been stopped after shutting off
the control power switch and shutting down the
vehicle.
6. Check that the vehicle and plow headlights are in
proper working condition including the turn
signals.
TESTING YOUR SNOWPLOW
On/Off Switch
(Emergency Stop)
(No LED Float Light or Indicator Light)
To prevent accidental plow activation, turn
POWER switch to the “OFF” position when
not in use.
BLZ 1017
WARNING
LED Float Light
On/Off Switch
(Emergency Stop)
Indicator Light
(Backlit)