– 5 –
ENGLISH
3-2. Ferrite Core (Europe only)
NOTE:Take special care when following the procedures listed below.
• Pass the fastener through the ferrite
core.
Fig. 3-3
• Pass the fastener around the cable
and lock it.
Cut off the excess with a pair of scis-
sors.
Fig. 3-4
Fig. 3-2
Fig. 3-1
■ A ferrite core noise filter for the
peripheral unit cable comes packed
with the printer.
■ The ferrite core is normally packed
so it is opened, as shown in Fig. 3-1.
If you find that the ferrite core is not
opened: Use a pointed object to pry
the plastic lock of the ferrite core
apart, as shown in Fig. 3-2. When
opening it, take care not to damage
the ferrite core or the plastic lock.
Pull and cut
One loop
Ferrite core (28mm diameter)
