Stabila HL-100 Manual

next previous

Level

The vial bubble (8) is precisely centered, using the vertical setting dial (3)

II. Aligning the laser dot horizontally (left - right):

Mark the horizontal position on the second joist / stud. (No need to measure

the vertical position). Turn on the laser(2). Dial the laser beam onto the mark

by using the horizontal setting dial (4).

ATTENTION :

To ensure that the HL 100 is set up to point in the right direction, it is

important that the lay out and drilling of the first joist/stud , as well as the

horizontal measurement on the second joist/stud is done accurately.

III. Aligning the laser dot vertically (up - down):

Slope

The vial's ring markings (8) allow the laser dot to be adjusted to an inclination,

up or down, of approximately 1% or 2%. Move the vial bubble accordingly by

using the vertical setting dial (3)

∆ = 1 %

∆ = 2 %

1 “