ADN CU1 | 19
Configuring the conference system
Working with the operating menu
By way of example of the “Microphone Limit” menu item, this section describes
how to use the operating menu.
Changing from the standard display to the operating menu
̈ Press the jog dial.
The standard display is replaced by the “Main Menu”. The last called-up menu
item is highlighted.
“Start Self-Test” Performs a self-test on the conference system “Yes”/“No“
“Reset Break Indication” Resets the error counter (“Break Count”) in the “Bus
Statistic” menu item
“Yes”/“No”
“Reset Error Indication” Resets the display for data bus errors (“Error Indication”)
in the “Bus Statistic” menu item
“Yes”/“No”
“Versions” menu
“Hardware Version Info” Displays the hardware version
“Software Version Info” Displays the software version
“Settings” menu
“Network” Calls up the “Network” submenu –
“Contrast” Adjusts the contrast of the display panel “1” ... “15”
“Lock” Activates/deactivates the lock mode “On”/“Off”
“Restore Factory Defaults” Restores the factory default settings “Yes”/“No”
“Network” menu
“IP Address Mode” Sets the IP address allocation mode “Static IP”/“Dynamic IP”
“IP Address” Sets the IP address of the central unit “xxx . xxx . xxx . xxx”
“Subnet Mask” Sets the subnet mask of the central unit “xxx . xxx . xxx . xxx”
Display Function of the menu item Option/display
No
Hardware Version Info
D1/C1: 1
CU1 SB: 1
PS: 1
No
Software Version Info
D1/C1: 0.1.1.5
CU1 SB: 1.0.0.0
CU1 Main: 1.0.0.0
„Main Menu“Standard display
Direct Access
30 Units
20
Main Menu
Conference
Audio
System
KA_ADN-CU1_546415_0911_SP13.book Seite 19 Donnerstag, 1. September 2011 11:00 11
