Beyond the basics
2.72
Setting scanner width
Your fax accepts original documents up to 8.5″ wide. The factory setting causes
your fax to scan the
middle
8.2″ of each 8.5″ page. However, if you wish, you can
increase the scanning width to the full 8.5″.
Note:
When your fax machine is set to scan the full width, certain documents will
require longer transmission times.
Important:
When you make this setting, you must turn your fax completely
off and then back on again before it will take effect. If this will
interfere with any delayed operations currently set on your fax, do
not make this setting until your fax has completed all of these
delayed operations.
To change your fax’s current scanner width setting to its maximum:
1.
Change to the Fax mode then press
PROGRAM
, *,
1
.
Set Memory Switch
Program/Enter
2.
Press
ENTER
.
A0: 00000110
Program/Enter
3.
Press
E
.
E0: 00000101
Program/Enter
4.
Press
ENTER
.
Set Memory Switch
E0 00000101
5.
Press or repeatedly until the cursor is under the
next-to-rightmost
character, as shown.
Set Memory Switch
E0 00000101
6.
Press
1
.
Set Memory Switch
E0 00000111
7.
To abort the change, skip to step 8.
To save the change, press
ENTER
.
8.
Press
STOP
to return to standby.
Note:
To return to the regular setting, repeat this procedure but press
0
(rather than
1
) in step 6.
