137 136
Do you want to convert or enable the
database?
Symptom: When you open MASTERFORM, you
receive a message box asking if you would like to
convert or enable the database.
Cause: This happens when you attempt to run an
Access 97 run time application on a computer
that has an early version of Office 2000 installed.
Resolution/Workaround: Microsoft addressed
this issue in an Office 2000 service pack. To
resolve the issue, you must go to the Microsoft
support site and download the latest Office 2000
Service Pack. (http://support.microsoft.com)
Run Time Error 9 in Configure Reports
Symptom: When you click a Configure Reports
report icon, you encounter a Run Time Error 9 and
cannot continue.
Cause: This is a known issue between Microsoft
Access and Hewlett Packard. It sometimes occurs
when you have an HP printer set as your default
printer.
Resolution/Workaround: To work around this
issue, set any other printer to be your default
(even adding a new, non-existent printer if
necessary) just long enough to get into Page
Setup or Configure Reports and complete your
settings. The default printer must not be a
Hewlett Packard. When you are finished, you can
reset the Hewlett Packard back to the default
printer.
Sometimes just changing the default printer isn’t
enough. You may need to delete your HP printer
altogether and then re-add it after you have
configured MASTERFORM.
Remember that Configure Reports is just a
shortcut to Page Setup. You may be able to enter
Page Setup at the end of the wizard (from the
Print Preview screen) and make all your setting
changes there.
