155
Chapter 8: Understanding printer messages
54 Par
x
ENA Connection Lost An External Network Adapter (ENA) that was once connected to the specified
parallel port is no longer responding. The printer only recognizes the missing
connection when the printer power is first turned on.
• Make sure the cable connecting the ENA and the printer is securely attached.
Turn the printer off and then on again to see if the printer recognizes the
connection.
• Press
Go
to clear the message. The printer erases any reference to the ENA
and then resets.
55 Insufficient Fax Buffer This attendance message may appear if the printer is processing a print job. The
printer must complete the print job before processing the fax data. If the fax buffer
is not large enough to hold the fax data, this message is displayed. After this
message is posted, the printer breaks the phone connection with the sending fax
machine.
The ability of the printer to process fax data exceeds the data transmission rate of
most fax machines.
• Press
Go
to clear the message and continue processing the current print job.
• Reset the printer. Press
Menu>
or
<Menu
until the Job Menu is displayed. Press
Menu>
or
<Menu
until Reset Printer appears on the second line. Press
Select.
56 Std Parallel Port Disabled Data was sent to the standard parallel port, but the port has been disabled from
the Parallel Buffer menu item.
• Press
Go
to clear the message. The printer discards the data sent to the
parallel port.
• Reset the printer. Press
Menu>
or
<Menu
. The Job Menu is displayed. Press
Menu>
or
<Menu
until Reset Printer appears on the second line. Press
Select.
56 Parallel Port
x
Disabled Data was sent to the specified parallel port, but the port has been disabled from
the Parallel Buffer menu item.
• Press
Go
to clear the message. The printer discards the data sent to the
parallel port.
• Reset the printer. Press
Menu>
or
<Menu
until the Job Menu is displayed. Press
Menu>
or
<Menu
until Reset Printer appears on the second line. Press
Select.
56 Serial
x
Port Disabled Data was sent to the specified serial port, but the port has been disabled from the
Serial Buffer menu item.
• Press
Go
to clear the message. The printer discards the data sent to the serial
port.
• Reset the printer. Press
Menu>
or
<Menu
until the Job Menu is displayed. Press
Menu>
or
<Menu
until Reset Printer appears on the second line. Press
Select.
58 Too Many Disks Installed You have more than one hard disk installed. Place the printer power off (O) and
follow the instructions in your
Setup Guide
for installing an optional hard disk.
61 Defective Disk The hard disk installed in your printer is defective. Press
Go
to clear the message
and continue printing. You must install a different disk before you can perform any
disk functions.
Attendance messages (continued)
Message Action
