b
b
37
Feed the power extension cable through
the leg: Insert the end of the cable in the
top hole (a) and pull it out of the bottom
hole (b). Push the hole covers back down
and tighten the screws (c).
Connect the power extension cable’s
plug end to the scanner.
38
Connect the scanner power cable to the
scanner power extension cable.
39
Connect the scanner power cable to a
power outlet (a) and switch the scanner
on (b).
40
Your scanner screen will ash on and
take you through your system’s installa-
tion steps. You start by calibrating the
screen. Touch the arrows at each corner
as they appear. Touch the middle dialog
to control and end the screen calibration.
41 42 43 44
System installation
Connect the scanner’s LAN cable to the
scanner.
Feed the LAN cable through the leg:
loosen the bottom screw on each hole’s
cover, and rotate the cover open to
expose the hole (a). Insert the free end
of the LAN cable in the top hole (b) and
pull it out of the bottom hole (c).
Plug the LAN cable into a connection
socket.
a
c
c
a
b
a
a
b
c
Learning Products Barcelona - Hewlett Packard Company
