A Summary of Commands stop_vs
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 596
stop_vs
The stop_vs command gracefully stops the voice system software.
Synopsis
stop_vs [time_out] [-n]
Description
The stop_vs command gracefully stops the voice system software. If the
system is receiving calls, stop_vs waits for approximately 3 minutes before it
unconditionally stops the software. By waiting, the system allows callers to
finish their transactions. The stop_vs command disables incoming call
recognition on all cards to prevent them from being reactivated by an
incoming call.
The time_out option is the time to wait before the voice system is stopped.
The default value for this option is 180 seconds. The -n option prompts you
with a message that another maintenance command (restore, remove,
attach, detach, diagnose) is being performed. It asks if you want to continue
or to terminate the stop_vs command. The stop_vs command terminates
another maintenance command in progress when initiated. The default value
for this option is Yes.
If you use stop_vs to stop the system, you should use start_vs to reactivate
it. If you use stop_vs to stop the software and then reboot the machine, be
