A Summary of Commands spar
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 576
• -l — feature licensing
• -m — mean (average) data
• -p — peak data
• -t — time; used to specify how many minutes of data are summarized in
each report line. The value must be 5 to 60, in increments of 5 (for
example, 5, 10, or 15, and so on). The default is 20. To ensure valid data,
the value for -t should be equal to or greater than the time increment
specified for data collection by the spadc command.
• -f — file; used to specify an input data file. If no -f argument is given, the
/var/adm/spa/mm-dd-yyyy file is used for the current day. If the data file
is not in /var/adm/spa, you must provide a full pathname to the input data
file.
Examples
Note that values of “NA” in a report indicate that data was not available for
that period, for example, if spadc data collection was not active, or if the
system had to be rebooted. A value of zero indicates data collection was
activated but no activity occurred.
spar -ap
This command creates a report showing peak percent usage for the entire
board and for each of the different algorithms allocated to the board. A partial
sample output is shown below.
