Lower-right cover and bracket
NOTE: You do not need to remove the sheet-metal bracket to remove the lower-right cover. However,
you must remove the bracket and the cover when removing some of the other product components in
this chapter. Use this procedure to remove the cover only, or the cover and the bracket.
1. Before proceeding, remove the following components:
●
DIMM cover. See
DIMM cover and DIMM on page 57.
●
Formatter cover and Formatter PCA. See
Formatter cover and formatter PCA on page 60.
●
Top-right cover. See
Top-right cover on page 73.
●
Control panel. See
Control panel on page 74.
●
Front-right and right-side cover assembly. See
Front-right and right-side cover assembly
on page 76.
2. To remove the cover and the bracket: Remove three screws (callout 1).
To remove the bracket only: Remove one screw (the bottom most screw in callout 1).
Figure 2-52 Remove the lower-right cover (1 of 4)
1
80 Chapter 2 Removal and replacement ENWW
