Hewlett-Packard P3010 Manual

A SERVICE OF

next previous

3. Carefully unwind the wire harness (callout 1) from the retainer on the gear cover (callout 2), and

then remove the cover.

Reinstallation tip When you reinstall the gear cover, make sure that you wrap the solenoid-wire

harness around the retainer on and on-half times in a clockwise direction.

Figure 2-108 Cassette pickup (Tray 2) or Tray 1 (multipurpose tray) solenoid (2 of 3)

1

2

4. For the cassette (Tray 2) pickup solenoid: Remove one screw (callout 1), and then remove the

solenoid (callout 2).

For the Tray 1 (multipurpose tray) pickup solenoid: Remove one screw (callout 3), and then

remove the solenoid (callout 4).

Figure 2-109 Cassette pickup (Tray 2) or Tray 1 (multipurpose tray) solenoid (3 of 3)

1

4

3

2

116 Chapter 2 Removal and replacement ENWW