Hard Drive
Appendix C: Installing and Removing Printer Options ❖ C-17
4
Align the hard drive connector to the
controller connector (J180), and gently lay
the hard drive on top of the four standoffs.
5
Push down on the drive until all four
corners latch into place.
6
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
7
Replace the power and interface cables
and power ON the printer.
If the drive is already formatted, the
Control Panel will display:
Online
Ready
If the drive is unformatted, the Control
Panel will display:
Press ↑ to Init
Press ↓ to Abort
If any other message is displayed, see
Table 6.2 starting on page 6-6.
If you need to format the drive, continue to
Step 8 on page C-18. Otherwise, skip to
Step 9 on page C-18.
kug-appc Page 17 Thursday, March 6, 1997 4:51 PM
