A SERVICE OF

logo

6-22 Removing and Replacing Parts
2 Facing the rear of the printer, release the 2 latches as follows:
Figure 6-18 Left end of Output Assembly (brass arm)
a On the left end of the assembly, rotate the brass arm up 90
°
.
Figure 6-19 Right end of Output Assembly (white tab)
b On the right end of the assembly, release the white tab.
3 Lift the assembly up and out of the printer.
CAUTION Lift the assembly carefully to avoid damaging the Top Output Bin full
sensor flag. When the assembly is replaced, the flag must be able to
rotate freely.