JETDIRECT
JETDIRECT
10/100 Base-Tx
(RJ-45)
10/100 Base-Tx
(RJ-45)
JETDIRECT
JETDIRECT
10/100 Base-Tx
(RJ-45)
10/100 Base-Tx
(RJ-45)
3. The HP 2500CM Professional Series Color Printer comes with an
internal JetDirect Print Server preinstalled. However, if you have
purchased the HP 2500C Professional Series Printer, you may
purchase the internal JetDirect Print Server and install it yourself.
For the list of supported JetDirect Print Servers, please refer to our
web site at www.hp.com/go/hp2500.
3.1 Installing the HP JetDirect Print Server Card
Step 1 - Verify the Printer Works
1. Turn on the printer.
2. Press [MENU] repeatedly until SELF TEST MENU appears.
3. Press [ITEM] repeatedly until PRINT DIAGNOSTIC PAGE appears.
4. Press [SELECT] to print the Diagnostic Page.
Step 2 - Install the HP JetDirect Print Server Card into the Printer
Note: The HP JetDirect card contains electronic components that can be dam
aged by static electricity through electrostatic discharge (ESD). To prevent ESD
discharge, maintain frequent contact with any bare sheet metal surface on the
printer. A grounding wrist strap (or similar device) is useful for this purpose.
Handle the card carefully at all times. Avoid touching electronic components
or circuit paths.
1. Turn off the printer and unplug the power cord.
2. Unscrew and remove the plate on the left of the printer.
3. Insert the card. Align the card with the guide rails in the printer.
4. Press the card into the slot until the card is firmly seated.
5. Tighten each thumbscrew a little at a time, alternating
between each side until both screws are secure.
6. Connect the network cable to the card.
7. Connect the power cord and turn on the printer.
2500C
HP
Installing The Print Server
