Load and Print on Roll-Fed Media 2-17
and calculating margins, to prevent printing on the media
edge holders.
11. Press the
9 (Yes) or ( (No) key.
• If you press Yes, the printer prompts you to position the
edge holders at the sides of the media. Then position the
edge holders.
• If you press No, go to step 12.
12. Press the ! (Proceed) key, or the Load/Unload switch on
the back of the printer to the Load position, or the optional
foot pedal switch (if installed).
The printer measures the media and lowers the pinch roll-
ers.
The control panel displays the message, “Media loaded suc-
cessfully,” and asks whether to save the Media Feed Num-
ber (MFN) for the current media type.
• To load the new MFN, press the
9 (Yes) key.
• To discard the new MFN and used the previously-saved
MFN, press the ( (No) key.
• To perform a media feed calibration or enter a different
MFN, press the Calibrate Media Feed key (For
instructions, see “Media Feed Calibration” on page 4-9.)
The Front Page screen appears.
13. On the Front Page screen, press the Go Online key.
14. Send a print job from the RIP.
Fig. 2-9. Media edge holder (left shown)
