Maintenance Menu Settings
Control Panel 2-25
Control Panel
Replace
The Replace selection initiates the replacement procedure
for the consumable items you are removing and replacing.
Follow the instructions in “Overview of Consumable
Supplies” on page 4-1 for replacing consumables.
Alignment.tray1,
tray2, tray3, hci,
duplex, and
duplexv
Sets the alignment correction values. See “Using Virtual Font Cartridges” on
page 6-26 for the paper path alignment procedure.
Density
1 (min)
= 10
15 (max)
This setting specifies the relative darkness of the print on a
scale of 1 to 15, with 15 being the darkest setting. Gray scale
patterns show the most visible effect. The effect of changing
Density can be seen immediately.
Note: The higher the density number, the quicker toner is
used. To conserve toner, use a lower setting.
Testpages
cont
1 (min)
=30
30000 (max)
Sets the number of pages printed when you print the
testpage in the Test menu. The cont selection causes printing
to continue until you press End and select ABANDON.
Monitor
= OFF
ON
Turns on a special area on the Control Panel which displays
printer registers. This should only be set to ON when directed
by your service provider for troubleshooting.
Date-Time
minute =0-59
hour = 0-23
date = 1-31
month = JAN-DEC
year = (last 2 digits
of year)
Sets the current date and time. The date and time is
displayed on the Control Panel and printed on all test reports.
