A SERVICE OF

logo

176 MFP disassembly/assembly ENWW
Replacing the wires
CAUTION After replacing or
reinstalling the wires,
manually rotate the
up/down drive shaft to
check that the tray moves
up and down smoothly.
Be sure to install the wires
so that they do not cross or
ride over each other.
Procedure
1 Remove the paper feed unit.
2 Remove three screws to remove the wire
cover (front) and wire cover (rear).
3 Remove the front and rear wires according
to steps 1 to 7 below.
Wire cover (rear)
Wire cover (front)
Screws (6)